how to hard reset Yakumo delta 300 GPS hard reset

Yakumo hard reset

Yakumo delta 300 GPS hard reset

Before you buy a new cell phone or new tablet, please try the following procedure to repair your device. First charge your battery, backup your important data if possible and in most cases take out SIM and SD card. It is impossible to recover your data after doing a hard reset, so online backup is always important. For all of your data, a backup should be done on an external device, hard drive, raid system or media.

Yakumo Delta 300 GPS Soft reset

Resetting Your Yakumo delta 300 GPS

CAUTION: Resetting will cause unsaved data to be lost.

Resetting your Yakumo delta 300 GPS is similar to restarting your desktop computer. It restarts the operating system, but you will lose any unsaved data.
Occasionally, you may need to reset your Yakumo delta 300 GPS; for example, you should reset:

• After you restore data from your desktop computer.

• When your Yakumo delta 300 GPS stops responding; in other words, it appears to be frozen or locked up.

Follow this procedure to reset your Yakumo delta 300 GPS:

1. Remove the SD/MMC card (if installed).
2. Use the stylus to press the reset button on the side of your Yakumo delta 300 GPS.

Yakumo Delta 300 GPS Hard reset

Restoring Factory Default State

In some cases, you may need to restore your Yakumo delta 300 GPS to the factory default state by clearing the memory (RAM) from your Yakumo delta 300 GPS. For example, you should clear the memory:

• When your Yakumo delta 300 GPS does not respond after being reset.

• When you forget your password.

Clearing the memory means all data you have entered in RAM, including all files, system settings and additional programs you have installed, will be erased.
(Programs installed to ROM at the factory are not affected.)

CAUTION:
To ensure the integrity of your data should it be necessary to clear the memory, you are advised to regularly back up your data.
Do not slide the ON/OFF Switch unless it is necessary.

Follow this procedure to clear the memory from your Yakumo delta 300 GPS:

1. Backup your information if necessary.
2. Disconnect all cables, including the AC adapter, from your Yakumo delta 300 GPS.
3. Stop all running programs by tapping Settings - System tab - Memory icon - Running Programs tab - Stop All.
4. Use the stylus to slide the ON/OFF switch to the OFF (up) position.
5. Wait for 1 minute and then slide the switch back to the ON (down) position.
6. Your Yakumo delta 300 GPS will automatically turn on and prompt you to start the setup wizard.
7. Follow the onscreen instructions to complete the setup wizard.
8. Reestablish a. partnership with your desktop computer.
9. You may also want to restore data to your Yakumo delta 300 GPS from your most recent backup file.

NOTE: If the battery completely runs out of power and is not charged in time, you will get the same result as you restore the factory default state.